*added 48khz, and 88.2khz sample rates.
* removed lots of ripples in the freq response, on both the low end and high end. all programs. now much more accurate.
* also cleaned up some noise and ripples in the harmonics.
* removed level difference between the stereo channels for the 1073 program. also done in the ‘lamney’ program.
* removed some of the higher harmonics. i looked at the original samples with analyzers and if they showed no harmonics beyond however many orders, i would remove everything beyond that. or if they were just very very low. some programs, like the ‘lamney’ ones, had such low harmonics, even for 2nd and 3rd order, that this meant removing everything above those. this results in all of the programs loading faster and using less CPU, which is good because the removed harmonics weren’t doing anything.
*harmonics levels have been completely rebalanced. usually this involved lowering the harmonics some, as they could get much too high and cause bad distortions if driven a bit too far. that can still happen but you have to drive them further now. and in most cases i think i got the harmonics levels to actually be more accurate to what was sampled.
Shopping Cart